The updated software received a range of additional advantages
A new version of the software for the parameterization of electricity meters UNIK v. 2.2.3.225.
In contrast with the previous UNIK 2.2.1.162 software, the updated software supports the entire new model range of the NIK electricity meters.
This new version of the software received a range of additional advantages:
- support of the Latin alphabet in the meter type up to 32x symbols
- installability of emergency tariff is added for all meters
- possibility of flexible adjustment of the load profile
- the following data is added to the name of the pdf file with the meter configuration:
- number of the meter;
- date of file creation;
- time of file creation.
Features of the version:
- Support of the entire new model range of meters (produced in 2017) in accordance with the approved names.
- For all meters, depending on displaying / hiding of the magnet reset buttons, on and off switching of the control output
- Reclaim error of Hi / Lo address record for the radio interface and its definition on the system
- Blocked updatability of the speed of the modular interface for NIK 2104 AP2TB meters ...
- For NIK 2307 meters, Ethernet interface settings are added
- Added information on the state of the GSM module as well as IMEI and software updates for NIK 2307 and NIK 2104 meters.
- At attempt of connection to the meters of previous generations there is a message about using version 1.1 on «NIK Parametrization»
- Current readings of the meter (in phases), parameters: Current rate(A); Voltage (V); electrical power factor; Frequency (Hz) were transmitted to the section «momentary value»
- Section «instantaneous power» renamed as «momentary value»
- New adjustments added for all meters to install LCD for all segments
- The insert «from the battery» removed from LCD adjustments for the NIK 2104 AP2TB meters
- For meters NIK 2303 ... E and NIK 2307 class 0,5s was added support of the network profile parameters
- Altered terminology and some menu names
- Installation and deduction of transformation ratio for 3-phase meters were added
- Time setting and time zone switching mechanisms were modified
- • Units of measurements were changed for configuration menu «Trip relay», «Control output» and insert «Limitations and rules»
- voltage: V (one decimal place);
- current: A (one decimal place);
- capability: W (integral value).